Editorial Note: We earn a commission on partner links on Forbes Advisor. Commissions do not affect the opinions or ratings of our editors.
Compare quotes from top rated local plumbers
Free and non-binding estimates
The average cost of plumbing repairs is not easy to determine. Whenever you need to contact a plumber for repair work, you will have an average bill of around $ 400. But, for major repairs that can range from a few hundred to several thousand dollars, you will benefit from several quotes for the work. That is, if you have time to do it before the problem gets worse or causes major inconvenience.
Plumbing repair cost explained
The hourly cost of hiring a plumber is only part of the service bill. The other charges included in the invoice are the cost of the parts, a percentage mark-up on those parts, and the cost of diagnostic inspection if necessary. Some plumbing companies will also charge travel costs for some work. Permit fees, if any, will also be added along with any unusual disposal fees incurred.
Small jobs may simply have a minimum charge which is the total cost of plumbing repairs. Certain tasks, such as light fixture replacements and minor repairs, will be billed at a flat rate, except in unusual circumstances.
Common plumbing repair costs
Daily life causes normal wear and tear on plumbing systems. It is likely that as an owner you will be faced with one, more or all of the following situations.
A blocked pipe
Most often, a clogged drain is a simple matter of an obstruction blocking the flow of water. A plumber can usually run only the affected drain for about $ 150 on average.
In the case of a larger save where multiple drains and the main house drain pipe are affected, you can expect to spend between $ 500 and $ 1,000 depending on the severity. This is especially common in older homes with older sewer plumbing. Repairing or replacing badly damaged sewer lines can cost several thousand dollars. You will probably want to collect a few quotes from different plumbers for this kind of project.
Supply lines and drain lines can both suffer from occasional leaks. Simple repairs to p-traps can be as minimal as $ 100. The most serious supply line leaks average around $ 500.
Valve repair or replacement
A dripping faucet may simply need to replace its internal components. This can be done by a plumber for about $ 100 to $ 150. If the fixture has deteriorated too much, the replacement installation will cost approximately $ 300, plus the cost of a new faucet.
Repair or replacement of toilets
Intermittent running water in the toilet is not only annoying, it can get expensive $ 200 to fix. If the toilet itself is the problem, expect to pay around $ 500 plus the cost of a new toilet to have it replaced.
Sump pump repair or replacement
Repairing the sump pump often comes down to replacing it. There are few moving parts. If they fail, the pump is usually no longer needed. Installing a new pump costs around $ 500, on average, to finish.
Plumbing fixture repair
Repairs and installation of devices can cost between $ 150 and $ 400. The price will depend on whether the device needs a simple repair, hookup or complete reinstallation.
Plumbing system repair costs
Bigger repairs, of course, cost more. Most homeowners will face one or more of these situations if they live in the home for more than several years.
Repair or replacement of water heaters
Water heaters will exhaust their life at any time after 10 to 12 years. It’s not uncommon to have to replace one if you own a home. Repairs can run nearby $ 500, while replacements start at around $ 1,000 and can go up to $ 7,000 or more for sophisticated systems.
Freshwater and water treatment system repair
Not everyone has fresh water and water treatment systems. If you do, be prepared to spend between $ 500 and $ 1,000 to fix them if they fail.
Repair of the main water supply line
In many cities, the main water supply lines are part of the city water utility. This responsibility usually ends where the water meter meets the plumbing in the house. If your city does not own it, or if you need to repair the pipes or valves beyond the meter, you can expect a $ 500 to $ 1,500 plumbing bill.
If the main drain in your home needs repair, the $ 500 that you will spend on the plumber is often the least expensive part of the equation. Main drains are generally buried well below the house where access is difficult. Digging to reach the pipe and reassemble the house after the repair is complete will likely be the most expensive part of the project.
Some sewer problems can be fixed without digging the ground. Unfortunately, this is still quite expensive to do and not always possible. Expect to spend around $ 4000 to $ 6000 for a major sewer repair.
Less common repair costs
The following plumbing repair items will not apply to every household or are rare enough that we hope you never have to face them. If you do, however, that’s what you can expect to pay.
Sometimes small sections of pipe need to be replaced. This can be done for as little as $ 300. If an entire house full of plumbing needs to be replaced, it can cost up to $ 7,000 depending on the house. If lead-based pipes are encountered, the law requires that they be replaced. It can add several hundred dollars to a simple repair.
Septic system repair
The location and access to a malfunctioning septic system are the main factors regarding septic system repairs. These repairs are on average about $ 2,000.
Well pump repair
If the water in your house is supplied by an individual well and it no longer works, it will cost you approximately $ 1,000 to have it repaired. This assumes that a major overhaul and deepening is not involved.
Emergency plumbing repair cost
If you can turn off the water and wait until the morning to call the plumber, you will save money. Emergency response plumbing will incur additional travel costs, at least $ 100, and 50 to 100% more per hour. Expect a surcharge $ 300 to $ 400 on the invoice, as a minimum.
Minimize your plumbing costs
Plumbing repairs can be expensive. There are, however, a few ways to lower your costs. These simple tips will leave more money in your pocket. A little plumbing know-how also provides peace of mind.
Maintenance work might seem expensive for what you get, but can ultimately save you a lot of money. Having your plumbing systems, heating boiler, water heater, and main drains inspected every few years will cost a few hundred dollars. The money saved by identifying potential problems early, however, can add up to a small fortune in avoiding large and unexpected repair bills down the road.
Some DIY maintenance can also be done periodically. Replacing the toilet flapper every two years is a simple thing to do that can save a lot of money. Quickly running sink drains every few months with a residential plumbing snake can prevent serious clogs from occurring. Checking the operation and battery backup of your sump pump before the onset of the rainy season minimizes the risk of potentially serious water damage.
The cost of plumbing repairs skyrockets when it happens outside of working hours. You can save money by delaying a plumber call until the next day. Locate the water shut-off valves for each faucet, toilet, water heater, and appliance and familiarize yourself with their operation.
If a leak or blockage occurs in the middle of the night, you can simply turn off the water supply to the offending device or hose and go back to sleep until morning, when it will be cheaper to call a service provider. plumber. Remember to turn off the gas or electricity supply to the water heater if you shut off the water to the water heater.
To prepare for a worst-case scenario, locate and learn to use the main shut-off valve for the home water supply.
Compare quotes from top rated local plumbers
Free and non-binding estimates